Wathai120x120x25mm 120mm 12V 0.45A 2Pin DC Brushless Cooling Fan

Perfect replacement for my GE Opal Ice Maker. As per instructions, this fan is slightly louder than the original, but not enough to make any difference considering where the ice maker is located. It is louder due to the 3K RPM rating which is fine with me because it operates at faster rotational speed (CFM) than the OEM version which makes the ice maker more efficient and produces ice a bit faster. The only anomaly is the power connector is not compatible with the controller board on the ice maker. I simply cut the old connector off the old fan and replaced the new connector on the new fan by soldering (blk to blk and red to red ) and using heat shrink tubing to protect the bare metal wire. You could probably use wire-nuts as well, but I prefer soldering.

The construction quality is excellent and the fan works quite well. Not sure how long the bearing is going to last, but I'll update this if it breaks after a few months of use or something.

Air goes brrrrrrrrr!

I bought this fan to see if I could fix a portable dehumidifier. It turned out to be a circuit board failure, so I didn't need it after all. However, the kit is well equipped, that fan seems to be decently made, and the harness connector fit properly.

This item was a perfect replacement. I used it to replace the cooling fan in bottom of upright drink cooler. My drinks were cold again. It hooked up just like the old one I took out. Very easy to replace.

These appear to be working diligently to cool my air compressor baffle box. One of them is used as an inlet fan and the other is used as an outlet.

I needed 4-pin fans for a PC build - now here I am a few months later looking for quieter ones.(Update) At full speed, the fans reach 2560 - 2580 RPM (Spec says 2500) But the blade design isn't allowing for maximum air movement - so they are making more noise than they should beOddly enough - I think the airflow direction arrows are missing? This is really a bad show in my opinion.I may try to lift them off of the case grill as this could be causing air friction.Update - The manufacturer reached out and offered a refund, which I declined. Nothing 'wrong' with these fans, they just need some updating / fine tuning.

Bought this to replace that fan in my 850w NZXT brand PSU that I've had for maybe 11 years now. My original fan had developed a rattle. I didn't want to replace the power supply as it was fine otherwise.The specs for my fan were 0.5a and 2500rpm. This fan was the closest I could find on Amazon to the original spec. It works perfectly. Even though it spins a bit faster it is pretty quiet. No louder than my original anyway.Solid buy.